• Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]
  • Custom Cages BMW Z3 Coupe - Multipoint [T45]

    • Custom Cages BMW Z3 Coupe - Multipoint [T45]

    Custom Cages

    €2,184.89
    (No reviews yet) Write a Review
    SKU:
    CCA-BMWZ3/02T
    Width:
    60.0 (in)
    Height:
    48.0 (in)
    Depth:
    12.0 (in)
    Shipping:
    Calculated at Checkout
    Adding to cart… category.add_cart_announcement

    Product Description

    BMW Z3 Coupe International Multipoint T45 roll cage kit. FIA Certificated

    FIA Certificated:

    • A certificated design is manufactured to meet the FIA / MSUK Roll Cage Homologation Regulations.
    • Usually, a ‘Multi-point’ design which adds stiffness and strength to the bodyshell.
    • These are almost always a ‘weld-in’ cage which is lighter and stiffer than a ‘bolt-in’ cage.
    • The designs are stress tested to prove their integrity and geometry, and tube sizes are optimised to give the best strength-to-weight ratio.
    • We always use high-tensile tube for these designs (normally T45, which has a tensile strength of min. 700 Mpa) to further enhance their advantages.
    • An FIA / MSUK certificated roll cage is accepted worldwide and enables competitors to run in any FIA-sanctioned event.
    • Can be as much as 20 kg lighter than an MSUK compliant design.
    • When correctly installed, they add value and saleability to a vehicle.
    • They are authorised in the UK by MSUK (the MSA as was), but the certificates are still referred to as FIA papers.
    • These regulations are constantly evolving, so new designs have to reflect these changes.

    MSUK Compliant – See our ‘National’ range:

    • The roll cage will be made using the minimum MSUK prescribed tube sizes – thicker gauge than we would use in a certificated design, and, so (unfortunately) heavier.
    • Usually, these are manufactured from CDS (Cold Drawn Seamless) tube – ours is a high tensile material with a minimum tensile strength of 510 Mpa – although T45 can be specified at extra cost.

    These cages are eligible for all MSUK events.

    Multipoint (weld-in) roll cage: These have a minimum of 8 point attachments. Please note, HOWEVER – Because our roll cage will fit very closely to the body-shell it would be normal practice to weld the cage to the shell in at least an additional 8 or 10 places, (and sometimes many more) making a minimum of 16 points.

    Weld-in roll cage kit: Our weld-in kits are supplied with all the parts you need to fit a roll cage. All the tubes are pre-cut and profiled to fit. They come complete with the footplates that get welded to the car, as well as all relevant gussets.

    SKU: BMWZ3/02T
    Category: BMW

    Product Videos

    Custom Field

    Product Reviews

    Write a Review